I got the front lighting look I wanted using front combination lights from a Suzuki Samurai. The lens is beveled and I thought the lights looked best with the bevel at the top so I have the lights flipped vertically and swapped to opposite sides. I’ll use LED bulbs for better output. I ordered another set of Hella 7″ reflector housings to install at the inboard headlight locations. I installed a new quick ratio power steering rack. The ‘refurbished’ rack I got from eBay for mockup was sprayed black (including the used tie rod boots) but there was little evidence … Continue reading Update 8/18/22: Front lights

I found a solution which allows me to mount 7″ headlights that are better suited for the period and styling of the car. The problem I was having is that most 7″ headlight housing are actually larger than 7″ in diameter due to the front side adjusting screws and retaining ring tabs, but the opening in the Lancia body is only about 7.25″—not enough room to mount standard 7″ headlight housings. I initially used LED headlights that have a rear-mountable housing but they didn’t look right (bottom picture). Also, I seriously doubt their DOT rating because the beam pattern is … Continue reading Update 8/14/22

The pedal ratio for the throttle is much better but the cable movement felt a little gritty, with a high initial break-away torque at the pedal. This was still contributing to some difficulty with the off idle throttle modulation. The original throttle body position required four tight 90 degree turns to pull down on the throttle body crank (top picture). I was able to clock the throttle body 90 degrees (bottom picture) allowing me to use fewer, more gradual bends in the cable routing. The operation of the throttle is now very smooth and the cable moves freely. I need … Continue reading Update 8/7/22

More driving video at the bottom. The car idles much better and doesn’t stall as often. The engine is torquey but falls off at higher rpms. I need to activate the VVT and intake flaps because that should help top end power. But off-idle power is very good and the car is very light. When I get a chance I’ll run the car through the scales at the local transfer station to get the total weight but I’m hoping around 2500lbs with driver. I added a crosswise stiffening rib to the front hood panel by using a pipe insulation sleeve … Continue reading Update 8/3/22

I fixed the squeaking/chirping sound from the serpentine belt. After installing a new tensioner and idler and still having the squeak, I ordered a 1/2″ shorter belt and that fixed it. I covered the intake side of the airbox with reflective tape where it’s near the exhaust and installed the oiled K&N filter. The front tire has a bad leak and drops below 10 psi in <24 hours. My tire choices in a 17″ rim are somewhat limited with the 315 rears. I’d like to get Nitto NT01 tires but the fronts are sold out everywhere. Available options in a … Continue reading Update 8/1/22