New plugs and oil+filter change. I found some stainless metric hardware to replace the oxidized coil pack bolts. Continue reading Update 3/11/15

I replaced the valve cover gaskets and the round seals at the spark plug holes. Continue reading Update 3/10/15

In the first two pictures you can see the fuel line routing, fuel filter and billet motor mount. Today I mounted the radiator cooling fans, attached a set of Hella hi/low horns to the bottom of the battery box and welded a bracket to the frame for the vacuum reservoir. Continue reading Update 3/8/15

The engine is installed for the last time (hopefully) using the billet 034 motorsport engine mounts and poly bushings. I plumbed the entire brake system, flared hard lines, etc, and fixed several leaks found during the bleed process. The Wilwood proportioning valve was defective and wouldn’t pass any fluid to the rear circuit. A replacement valve fixed the problem. I need to run a vacuum hose from the engine for the reservoir which provides vacuum to the brake assist booster. I mounted the Bosch fuel pump under the fuel tank and ran AN lines to/from the engine. I’m using a … Continue reading Update 3/4/15